Canon cameras come with straps that help you hold the camera securely. Follow these steps to put the strap on your camera:
– Open the camera’s lens cover.
– Find the strap clip and insert it into the hole on the camera body.
– Pull the strap clip towards you until it snaps into place.
– Close the lens cover.
Contents
Attach a Neck strap to your DSLR camera…The Canon way!!!
[ytvideo]
How to put the strap on your Canon camera
There are many different straps available for Canon cameras and most of them work in a similar way. To put the strap on your camera:
1. Open the camera’s back cover and locate the strap hinge.
2. Push the strap hinge down and towards the camera body.
3. Line up the strap’s fastener with the strap opening on the camera body.
4. Push the strap fastener into the strap opening.
5. Close the back cover.
The best way to put the strap on your Canon camera
There are a few different ways to put the strap on your camera depending on the model you have. The following is a guide to the most common way to do it.
If you have a Canon EOS Rebel T3i / T3 / T1i / T5i / T5 / T4i / T4 / T3iS / T3 / T2i / T1iS
1. Open the camera’s back cover and locate the lens barrel.
- Push the camera’s lens barrel all the way back until it clicks into place.
- Make sure the camera’s lens is snapped into place by gently pushing down on the barrel from the front.
- Push the camera’s strap mount down into the camera’s body. It should snap into place.
- Push the camera’s strap mount up so that it’s flush with the camera’s body.
- thread the strap through the strap mount and tighten it by twisting it in a clockwise direction.
- Make sure the camera is securely fastened to your arm by adjusting the strap length.
- Close the back cover and you’re ready to take photos.
How to keep the strap on your Canon camera
Canon cameras come with a strap that attaches the camera to your hand. To attach the strap, find the loop on the strap and thread the end of the strap through the loop. Make sure the button at the end of the strap is facing out. Push the button to tighten the strap.
How to take care of your Canon camera strap
Canon camera straps are often overlooked, but taking good care of them will ensure that your camera stays in good condition and works as it should.
To put the strap on your camera, first make sure that the camera is turned off. Then, remove the battery and memory card. Next, detach the lens from the camera body by pressing down on the lens assembly and pulling it outward. Finally, remove the strap by unfastening the buckle.
To keep the strap looking new, avoid harsh detergents, chlorine, and excessive sunlight. Instead, clean it with a mild soap and water solution. To restore color and brightness, use a gentle conditioner.
If the strap begins to show signs of wear, such as fraying or tearing, replace it immediately. To replace the strap, first unfasten the buckle and unsnap the strap. Take off the old strap and replace it with the new one. Then, fasten the buckle and unsnap the strap.
The best way to clean your Canon camera strap
There are many ways to clean your Canon camera strap, but the easiest way is to use a microfiber cloth. Simply wipe down the strap with the cloth, making sure to get into all the nooks and crannies. If necessary, use a little bit of cleaning solution to get the strap really clean.
Conclusion
Putting the Canon strap on a camera can be a little tricky, but with a little patience and some help from YouTube, it can be done.